greddy type s

[Eric Ringrose]

so after hearing calvins bov i decided i needed to have one, and i picked it up tonight

now i need to install it hehe. i did a search and found a few things marty had said

"Intake manifold (post tp) boost source to large nipple.
Pre-throttle plate,Post I/C boost source to smaller nipple."

the large nipple would be where the stock vacuum line would be, but how do i set up the small nipples vacuum line?

also, i know it's possible to use the stock 1G flange to mount the Type S, but is it really as simple as drilling new holes? what about the gasket...trim it to fit the greddy?

thanks for your help

[Calvin Ng]

just use the gasket that came with the bov should work just fine

martys not cool cuz hes recirculating haha i'm rice therefore i'm venting haha

make sure the holes are lined up on the stock flange and drill drill drill!

good luck