Meth tank leaks... Sealant recommendations?

[CamWeiss]

So... I gots a question.

For all of you running meth, either smurf blood or stronger, what do you use as a sealant?

I'm using a 1 gal AEM tank. One of the fittings is leaking, I had previously bedded it in epoxy which is obviously not holding up as well as I thought it would.

So what would you use? RTV? More epoxy? Something else?

(I also noticed that my cap is cracked, I don't think sealant is going to hold that together...)

[Drew Sale]

What's the tank made of?

[Rob Armstrong]

Jb weld. Not sure about it with meth but I have used it on my rad to patch a hole that I could fit a fat finger in.
It held for over a year till I sold my jeep.

[Brett Haviland]

umm...  i think i used teflon thread sealant tape when i put the fittings into the AEM meth tank... or it might have already came pre-assembled with the quick release fittings already installed.

[Zach Holt]

Meth eats aluminum. Don't use jb. Replace fittings if all else fails.

[Jordan Kruger]

use teflon. 

[CamWeiss]

Thanks guys.

Might try a fuel-safe polysulphide sealant - It's just basically a bung I need to stick back in. I don't have the low level sensor that there's a hole for.

If I can make it thread, pfte tape it is.

[Allen fong]

Cam i have some aircraft shit i used on my worked with the tank tap and with an AN fitting! shoot me a text! if you wanna try it

[Lowell Foo]

Since your lid is cracked as well, might want to consider upgrading:

http://www.coolingmist.com/pagedisplay.aspx?pid=Protankred

[Brett Haviland]

Yeah, the aem caps are shit... My buddies cap cracked as well on his 1gallon aem tank too...