« previous next »
Pages: [1]

Author Topic: FIAV plate install  (Read 351 times)

Offline BrandonDouglas

  • Jr. Member
  • **
  • Posts: 88
    • My pictures
FIAV plate install
« on: December 01, 2011, 04:47:40 pm »
Just received my FIAV bypass plate in the mail from Level Zero, I'm going to order a new FIAV seal as well as a new BISS, o-ring and cap all from RTM Racing.

1) Is there any other seals/gaskets I should replace while I"m in there?

2) Any tips? I assume its pretty straight forward, just unbolting the TB, but I've never done it before.
Logged

Offline Jordan Kruger

  • Senior Member
  • Hero Member
  • *
  • Posts: 2210
Re: FIAV plate install
« Reply #1 on: December 01, 2011, 05:02:44 pm »
when you take the bottom portion of the tb off there is a rubber gasket that seals off the idle air from the water journals. Just be careful not to rip the gasket when pulling the bottom portion of the throttle body off.   Yours is most likely fine to re-use aslong as it isnt ripped.  I lightly rubbed grease on the gasket to prevent it from getting brittle.
« Last Edit: December 01, 2011, 06:06:12 pm by Jordan Kruger »
Logged
337awhp.  ---> 500 awhp ? =)

Replacing parts since early 2010.

Offline Jordan Kruger

  • Senior Member
  • Hero Member
  • *
  • Posts: 2210
Re: FIAV plate install
« Reply #2 on: December 01, 2011, 06:07:53 pm »
google   -   fiav dsm

images   - first picture


 you can also email Ziggy at RTM.   let him know a scenerio and he will run you through you best options.
« Last Edit: December 01, 2011, 06:10:47 pm by Jordan Kruger »
Logged
337awhp.  ---> 500 awhp ? =)

Replacing parts since early 2010.
Pages: [1]
« previous next »