Yep I was on DSMtalk, and it was the rear bearing. I didn't get it apart. I ended up putting the thing back together. I need it done though. I will probably take it to a shop and get it done now, hopefully they don't charge me too much because it is so stuborn. I am in Kelowna or I would bring it to you, Lowell.
I might have to remove the whole trailing arm and then put it on a press.
I don't understand Ryan's post about the backwards rotor. I have an old rotor but what do you press the puller against? If it is a typical three jaw puller then the center must push on something but the axle is solid so it would be just pressing against itself. This is an AWD if that helps.
Thanks
Trevor